First try-outs: iteration 01

To kick-off the project, we made some quick and dirty prototypes out of scrap-materials. The goal was to test some hypotheses and to check the information we got out of the 1st meeting at the zonnebloem.
Main conclusion: this will not be as simple as we hoped for... Lots of work to be done!

Prototype 1: round table  

	expected	unexpected
Pos	*Height of the table is OK	*Easy to put him in, because ther is no need to take him up. There is nothing tn the way at the back side.
Neg	*Support is not good enough, more side-support needed, more fixed support needed, straps are not good! *Height of the seat is'n adjustable	*Width at base isn't enough → no room for his feet! Seat is to wide, (maximum 5cm)

Prototype 2: square table 

	expected	unexpected
Pos		* much room for the legs
Neg	*Support is not good enough, more side-support needed, more fixed support needed, straps are not good!	*Table to low, should be almost under his arm-pits *Difficult to put him in, because of the metal tube, between the back-legs of the device